The magnetic separator motor overheating and sound not normal. Caused by the above reasons, including: bearing bad lubrication or severe worn , fan leaves fall off or wear ; Switch line contact undesirable , or disconnected to run single-phase ; voltage is too low.
Magnetic separator noise is not normal in normal operation, the cylinder was jammed by obstacles and even the cylinder cannot rotate, the bottom bin vibrates. Caused by these reasons include: magnetic separation was jammed by the bottom bin of object, or magnet fell off, causing the cylinder rattled, serious causing cylinder of epidermal was lacerated. At this time we should shut it down for maintenance and troubleshooting. Its main causes: lack of oil or oiliness is bad; gear and worm wear serious, or meshing is bad; bearing lubrication is bad, or badly worn.
Magnetic separator of magnetic field intensity becomes weak. The major reason, including: the temperature is too high; sun exposure; acid and alkali corrosion. You can use Gaussian measurement meter.
Magnetic separator is composed of foundation bed, the magnetic system under, the rotating cage, the magnetic system above, hollow shaft, concentrate hopper other rotating equipment. Mounting base should to make hollow bearing seat as a criterion to measure the elevation and level of degrees. The positioning of the magnetic system under should make mounting base as the criterion. Turn cage, next step is the upper and lower magnetic system must be accurate adjustment of the gap, which limits of deviation of 0 +1 mm.
As the professional manufacturer of complete sets of mining machinery, such as Primary crushers，Raw material mill，Primary crushers，Mobile crushers,Henan Hongxing is always doing the best in products and service.
